By default this section is already set to 1 so just leave it there. This section will set up the tone of each of the sections you just configured in the previous steps above. Minelab CTX 3030: Should You Ground Balance? Why, When, and How-to - Micro-Session #4īy pressing the Gear/Setting button move over to the Target/Tone menu option and hold for 2 seconds to get into the advanced options. Here is what your screens should look like after all the sections are set up. Move cursor UP to 11 and hit the Accept/Reject button. This time around (not sure why) you can advance from 9 to 11. Move cursor DOWN to 21 and hit the Accept/Reject button Move cursor DOWN to 17 and hit the Accept/Reject button Move cursor UP to 13 and hit the Accept/Reject button We’ll come back to Section 1 after we configure Section 4. Simply press the Accept/Reject button to advance to the next section. Please beware! You will NOT be able set up section 1 to 11 just yet. Adjust each section to the following settings below: By default you are starting in Section 1. This will allow you to set up tone breaks by each section. Press and hold for 2 seconds to move into the advanced options. Using the Gear/Settings button (the one in the middle), move over to the Accept/Reject button. Make sure the Equinox is powered up/turned on. (Note: Before we start setting up the program, I recommend doing a factory reset by pressing and holding down the power on button.) To set up the Andy Sabisch Coin Program for the Equinox 800 requires some knowledge of how to get around to the advanced features of the Equinox but I’ll walk you through setting up the program.

Minelab ctx 3030 programs